Shanghai Clirik is a professional grinding mill and powder grinding machine and crusher industry companies, the production of hammer crusher is a best-selling crusher equipment is usually the most widely used to remind you to use a device .Clirik hammer crusher which we should pay attention the problems?

        

First, the use of hammer crusher, a sudden failure if the device is in operation, we can stop the job, and then find out the root of the problem, it must not be forced open. Secondly, if the inspection process, we found fault hammer crusher belongs to electrical equipment appeared, then we should ask the electrical staff to be responsible for processing, must not act reckless! Furthermore hammer crusher after failure, need someone to check into the inside of the machine, remember to pull out all the power switch, and clearly marked "Someone overhaul" to remind others not to start to use. Because someone enters the inside of the machine, it should be preceded by checking out all the material to clean the upper part of the machine, to avoid falling injuring others. After we checked, we must cover to cover, bolts to tighten. Finally, all the safety devices throughout the hammer crusher equipment must be firmly intact before use to confirm that it has no security risk, if you find contact signal or communication equipment failure, must not start hammer crusher.

         

Another point is that the efficiency of the problem:

1. The choice of materials is crucial. In the choice of materials, pay attention to the hardness of the material. Harder materials broken up more difficult, but the wear and tear on the equipment more serious. Broken slow, natural crushing capacity is small.

2. The material moisture is the key,large material containing water, the material is easy to adhere to the crusher content, but also easy to jam during the next conveyor, resulting in crushing capacity is reduced. Therefore, before crushing it should try to find ways to reduce the water content, in order to better work in the hammer crusher.

3. After the finer crushed material for crushing fineness requirements, which requires breaking out of the material, the crushing capacity is smaller.

4. Composition of broken material, the more broken material in the former powder containing more impact crusher, because these fines easy adherence of delivery. For more fines content should advance once sieve.

5. Material viscosity: the viscosity of the material, the more likely adhesion.

Broken pieces (hammer, jaw) wear 

6.hammer crusher crushing equipment, the better the greater the ability, if not wear, will affect the crushing capacity. Shanghai Clirik mechanical aspects of quality assurance in wear, reach high efficiency crushing performance.