Order Online Contact Us

Products list

News list

News

Home > News >

Eight Steps of Installation and Commissioning of Hammer Crusher

Time:2013-10-25 10:45    Author:clirik

Clirik hammer crusher is using high speed rotating hammer blow to materials of broken equipment. It is suitable for metallurgy, mining, cement, construction, refractory materials and ceramic industries, for barite, limestone, gypsum cement mill, coal, slag etc. Various kinds of hard and soft ore for crushing and finely homework.

Large machinery and equipment used in formally put into production, goes on trial to test various performance of equipment. CLIRIK on the basis of scientific production planning, reasonable arrangement of the installation and commissioning of hammer crusher, which is divided into eight steps:

1, Before the installation can be chosen according to the sources of raw materials of good terrain.
2, The machine by the anchor bolt on the concrete, to allow drainage trough design foundation, the slope can not less than 50 °, but the user can also according to the feeder and transport equipment
3, The motor should be in with the inlet in the opposite direction.
4.Electrical equipment is better to use convenient position
5, Before commissioning should first check the fasteners are firm.
6.Check whether the body into metal or other easily broken fragments
7, check whether the bearing inner appropriate lubricating oil
8.Turn the rotor by hand, to see if it is normal, with or without friction phenomenon, if confirmed for sports shine, before starting, empty test after half an hour without noise, no swing, can into the bearing temperature rise shall not exceed 30 ℃.

Shanghai Clirik Machinery Co.,Ltd 2013-2016 all rights reserved.    Address:No.19Fuqing Rd,Shanghai SITEMAP